![]() Switching back to the cohesion 3d Mini, (with everything powered down), full reboots of computer… Reconnecting the stock board, the Y axis works correctly. Hitting home pushes the head far left (correct), but keeps doing so for that 10+ seconds, even if homes again right after homing once. +Ray Kholodovsky I have tried absolute positioning. When I hit HOME, it homes the X, though doesn’t recognize when to stop and spends 10-20 seconds vibrating like crazy trying to go beyond where physically possible (moving left). I still have zero motion in my Y positioning (from starting a program or using the direction controls in lightburn). +Ray Kholodovsky My mistake, I can now control my X position in lightburn. It is intermittently controlling the X position (not by the movement controls in lightburn, though, but by having it START a small design. Rebooted it (powering down, unplugging USB). I get this in the console, and then nothing while it finishes sending.Ĭhange Start From, from current position to absolute coordinates. +Ray Kholodovsky Switching the port from auto to Com 8 (the suggested one) lets me get a bit farther, but still no motion occurring. +Ray Kholodovsky I’ve switched between 3 different USB cords, including the stock. +Ray Kholodovsky I used my 32GB card (not a permanent solution), and now have all lights as expected.Įrror:Alarm lock is constant in the console, and I can’t move anything via lightburn.Īre you using the stock K40 USB Cable? Don’t. Do you have a different card you can try to use? Just need to format it FAT32 and put the config and firmware files on it - these are located in a dropbox at the bottom of the install guide. If I remove it an check it on my computer, it will not read the card. I can’t read it at all on my computer, though. (My K40 uses the connections shown here: and I’ve plugged the 3 plugs in and the USB as shown in this image) ![]() Sage advice and wisdom is much appreciated! Using a backup power-supply sees the exact same thing happening. Without the K40 powered on (only USB), the same things happen, without the VMOT lighting up. ![]() I’ve just installed the Cohesion 3d Mini in my K40.ģV3 solid green (very hard to see as VMOT red is so bright) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |